How can I capture an error?

[ccascante]

Hi there,

I'm working in an application that saves the last cube and map structure used by the user.

If I make a change to the structure of the cube, when I load the map I get the next message:

"The loaded map is not compatible with currently loaded cube, Measures are mismatch"

Some other times I get : "Cube structure is not defined"

I know the reason why the error occurs, but I need to capture the error in order to send a message to the user informing that the cube has changed and it's necesary to delete the map and the cube saved before. Also run a procedure that deletes that files.

I was looking for a OnError event on the Active X and I didn't not find it.

Best regards from San Jose, Costa Rica

[AlexZencovich]

Try to put load procedures in try..except block

[ccascante]

Sorry Alex, but I didn't get it.

Would you mind to extend your reply, maybe with a example code.

Thanks.

[AlexZencovich]

try something like

try
PivotMap1.LoadFromStream(Stream);
except
ShowMessage('Cube are different! Please do not use old savings with new cube');
end;

[ccascante]

Alex,

I'm working with the ActiveX Control and Visual Basic 6.0. I Think you should include a OnError Event to the control.

Best regards

[AlexZencovich]

I'm working with the ActiveX Control and Visual Basic 6.0

In that case you should write your questions in PivotCubeX forum.

I'm not prophet

[AlexZencovich]

BTW, you are right there should be more affordable error catching scheme. I will think how to change current way