If I load a cube file, how can I know the number of facts. This would be equivalent to FactTable.RecordCount. However, with a cube that is loaded, there is no factTable.
Regards
Jose Ostos
How can I know the number of facts.
Moderator: Alex Zencovich
3 posts
• Page 1 of 1
How can I know the number of facts.
by jostos » Thu Nov 09, 2006 1:11 am
- jostos
- Guest
- Posts: 4
- Joined: Mon Jun 19, 2006 5:20 am
- Location: Mexico
by AlexZencovich » Thu Nov 09, 2006 7:45 am
Yes, you are right it is impossible to get record count for loaded cube.
There is property CubeLength (PCX.CubeIntf.CubeLength) which will return number of cells in cube (it may be same as record count or less if cube was aggregated)
There is property CubeLength (PCX.CubeIntf.CubeLength) which will return number of cells in cube (it may be same as record count or less if cube was aggregated)
Best regards,
Alex Zencovich
-------------------------------------------------------------------------------------------------------------------------------------------
www.pivotcube.com - OLAP solution for Delphi, C++ Builder and ActiveX environment
Alex Zencovich
-------------------------------------------------------------------------------------------------------------------------------------------
www.pivotcube.com - OLAP solution for Delphi, C++ Builder and ActiveX environment
- AlexZencovich
- Site Admin
- Posts: 580
- Joined: Sun Jun 18, 2006 10:09 am
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests