PivotCube VCL 7.5.2.120 uploaded

[AlexZencovich]

New

1. Delphi XE units included in package

2. Few bugs fixed

[DPiethan]

Hi Alex,

where I can find the download for the non source distribution? On your home page I can find a version, but it include no XE folder.

best regards
Dirk Piethan

[AlexZencovich]

Hi Alex,

where I can find the download for the non source distribution? On your home page I can find a version, but it include no XE folder.

best regards
Dirk Piethan

That is included. Please look at /D_XE subfolder. But may be you have to re-download a package again, there was a problem with installer

[DPiethan]

Hi Alex,

I have run the installer on a new system, now I find the folder D_XE, but the file PivotCube.dbk isn't included.
I try to test a copy of this file from 2010, but I can't compile the package.

[code][DCC Fataler Fehler] LicenseKey.pas(9): F2051 Unit PivotGrid_SRC wurde mit einer unterschiedlichen Version von TeEngine.TChartSeriesClass compiliert[/code]

I use DXE with update 1! What is wrong with the installation tool?

best regards
Dirk Piethan

[AlexZencovich]

Hmm..that is a bit strange as LicenseKey.pas does not refer on any unit. That error message looks like it try to use precompiled dcu from some other source.

[DPiethan]

Sorry, but some thing is going wrong! I have tried to install your compiled PivotCube.bpl package, but i can't install it,
it don't like the "Tee9150.bpl".

So I get a new error message "Der Prozedureinsprungpunkt "@Teengine@TChartValueList@GetCount$qqrv" wurde in der DLL "Tee9150.bpl" nicht gefunden."
I deleted all old files of "tee" which I have found on my disk.

Have you any idea?

best regards
Dirk Piethan

[AlexZencovich]

I look for the problem source. as I can see that may be an cause with Delphi XE update 1 - I look in the Web and it looks it is not only just one problem with it. I will try to reinstall Delphi and start again

[AlexZencovich]

I just uploade fixed (I think) version of package.