Hi,
If you have more than 1 analyze data in the application, I have more than one (1) pivotcube in the form? or there is a way for him to carry to various queries.
Other.... help at development formulas...
Question at PivotCube
Moderator: Alex Zencovich
3 posts
• Page 1 of 1
Question at PivotCube
by José Luiz » Thu Nov 27, 2008 11:58 pm
- José Luiz
- User
- Posts: 15
- Joined: Wed Nov 26, 2008 8:52 pm
Re: Question at PivotCube
by AlexZencovich » Fri Nov 28, 2008 6:09 am
You may have different components if you need that at one time (at least you have 2 grids to show data at runtime, right?) or switch settings at runtime if you not need it at one time - then better to use runtime configurations procedures
Best regards,
Alex Zencovich
-------------------------------------------------------------------------------------------------------------------------------------------
www.pivotcube.com - OLAP solution for Delphi, C++ Builder and ActiveX environment
Alex Zencovich
-------------------------------------------------------------------------------------------------------------------------------------------
www.pivotcube.com - OLAP solution for Delphi, C++ Builder and ActiveX environment
- AlexZencovich
- Site Admin
- Posts: 580
- Joined: Sun Jun 18, 2006 10:09 am
Re: Question at PivotCube
by José Luiz » Fri Nov 28, 2008 10:30 pm
Okay, tanks I use the procedures run time.
- José Luiz
- User
- Posts: 15
- Joined: Wed Nov 26, 2008 8:52 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest