I have a 10 dimensons cube and only one measure. In the project I have PVDimTollBar, PVColToolBar and a PVRowToolBar.
When I try to move the 10th dim to the PVDimToolBar I get a "List out of bounds[0]" error. If I keep any dimension in the PVColToolBar or PVRowToolBar everything is OK.
Step by step, until I had only 9 dimensions, all was OK.
Tks and best regards.
List out of bounds[0] error
Moderator: Alex Zencovich
2 posts
• Page 1 of 1
List out of bounds[0] error
by anaves » Mon Oct 30, 2006 3:32 pm
- anaves
- Developer
- Posts: 25
- Joined: Mon Oct 30, 2006 2:06 pm
by AlexZencovich » Mon Oct 30, 2006 4:48 pm
I could not reproduce problem on my side by now. I will check problem mopre carefully in few days and inform you
Best regards,
Alex Zencovich
-------------------------------------------------------------------------------------------------------------------------------------------
www.pivotcube.com - OLAP solution for Delphi, C++ Builder and ActiveX environment
Alex Zencovich
-------------------------------------------------------------------------------------------------------------------------------------------
www.pivotcube.com - OLAP solution for Delphi, C++ Builder and ActiveX environment
- AlexZencovich
- Site Admin
- Posts: 580
- Joined: Sun Jun 18, 2006 10:09 am
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 14 guests